Urban surface parameters

Steering

String2

String3

Since r19xx an urban surface model (USM) is available in PALM. A brief description of the USM will follow here (see LSM description as an example).

NAMELIST group name: urban_surface_parameters

---

Steering:

Parameter Name	FORTRAN Type	Default Value	Explanation
building_type	I	1	Defaul category of buildings. Default value 1 represents old residential building.
land_category	I	2	Land surface category. Default category for land surface.
naheatlayers	I	1	Number of anthropogenic heat layers. Number of layers where the anthropogenic heat is added into model.
pedestrian_category	I	2	Pedestrian wall category. Default category for wall surface in pedestrian zone.
read_wall_temp_3d	L	.F.	Read wall temperature initialization file. Initialize temperature of wall layers and surfaces from supplied file instead of using default profiles.
roof_category	I	2	Roof category. Default category for roof surface.
roof_inner_temperature	R	295.0	Inner temperature of roofs. Temperature of the inner roof surface (inside the building)(K). The value is not used in case of using indoor model.
roughness_concrete	R	0.001	Roughness length of concrete. Roughness length of average concrete surface (m). This values is used to calculation of roughness relative to concrete.
soil_inner_temperature	R	288.0	Deep soil temperature. Temperature of the deep soil. (K)
usm_anthropogenic_heat	L	.F.	Anthropogenic heat. Enable supplied anthropogenic heat in USM model.
usm_material_model	L	.T.	Material heat model. Switch on calculation of propagation of heat in grounds, walls and roofs
usm_wall_mod	L	.F.	Wall conductivity reduction. Reduces conductivity of the first 2 wall layers by factor 0.1.
wall_category	I	2	Wall category. Default category for wall surface over pedestrian zone.
wall_inner_temperature	R	295.0	Inner wall temperature. Temperature of the inner wall surface (inside the building)(K). The value is not used in case of using indoor model.
window_inner_temperature	R	295.0	Inner window temperature. Temperature of the inner window surface (inside the building)(K). The value is not used in case of using indoor model.