Nesting parameters

NAMELIST group name: nesting_parameters

Parameter Name	FORTRAN Type	Default Value	Explanation
anterpolation_buffer_width	I	2	Width of the anterpolation boundary buffer in terms of number of parent-grid points. If anterpolation_buffer_width = 0, anterpolation is carried out for all parent-grid points inside the child domain except the grid planes next to the boundaries. By setting anterpolation_buffer_width > 0, makes these buffers wider accordingly. The same value is applied to all nested boundaries.
anterpolation_starting_height	R	0.0	This parameter controls the canopy-restricted anterpolation. It is the height in metres relative to the local terrain height above which the anterpolation is performed in case of two-way coupling. Below this height no anterpolation is made. It is recommended to select this height in such a way that most of the building roofs, or even all of them depending on the case, are below this height.
domain_layouts	derived TYPE pmc_layout(64)	none	General information about the nested domains to be used. Up to 64 domains can be used. The derived data type has the structure TYPE pmc_layout CHARACTER(len=32) :: name INTEGER :: id INTEGER :: parent_id INTEGER :: npe_total REAL(wp) :: lower_left_x REAL(wp) :: lower_left_y END TYPE pmc_layout name is the domain name given by the user. id is the number of the domain (can be arbitrarily chosen, but it would be good practise to number the domains in ascending order starting with 1), while parent_id gives the number of the domain in which this domain is embedded. The so-called root-domain which includes all other nested-domains should have the id 1. The root-domain has no parent-domain and must be given -1 as its parent_id. npe_total is the number of PEs to be used for this domain. lower_left_x and lower_left_y are the coordinates in m of the south-left corner of the domain given in the root-model coordinate system. More precisely, lower_left_x is measured from the u-node at i=0 and lower_left_y from the v-node at j=0. The root-domain has lower_left_x = 0.0 and lower_left_y = 0.0. Note that lower_left_x must be integer divisible by the parent grid dx and similarly lower_left_y by the parent grid dy. A nested-domain must be completely embedded in its parent-domain and there has to be a clearance between the lateral nest boundaries and its parent boundaries. This clearance has to be at least four parent-grid cells in case of Wicker-Skamarock advection scheme and at least two parent-grid cells in case of Piaseck-Williams advection scheme. Possible parallel nests, including their ghost-cell layers, are not allowed to overlap. The following gives an example for defining a single nested-domain embedded in a root-domain: domain_layouts = 'coarse', 1, -1, 16, 0.0, 0.0, 'fine', 2, 1, 16, 320.0, 128.0, The total number of MPI-processes required by this configuration is 16 + 16 = 32. The numbers of PEs in the x- and y-directions can be additionally specified by setting npex and npey in &runtime_parameters for the respective domain. Of course, the condition npe_total = npex * npey must always hold.
nesting_datatransfer_mode	C*7	'mixed'	Type of nesting datatransfer mode. cascade, overlap, or mixed data transfer mode is allowed.
nesting_mode	C*7	'two-way'	Type of nesting mode. one-way, two-way, and 'vertical' nesting are allowed. The latter implies of a one-dimensional nesting in the vertical direction only (i.e. all domains have the the same horizontal extent).
particle_coupling	L	.T.
switch_off_module	L	.F.