Changes between Version 38 and Version 39 of doc/app/maskedoutput

Timestamp:

Sep 16, 2010 2:52:29 PM (14 years ago)

Author:

weinreis

Comment:

--

doc/app/maskedoutput

@@ -48 +48 @@
 == Examples ==
 The following examples are given for the [../examples/cbl example_cbl run] with a model domain of 2000m x 2000m x 2000m and a resolution of 50.0m.
+\\
 === 1. Output of one mask ===
 '''Mask 1:''' 3d volume data with an extension of 500m x 200m x 2000m from x = 0m to x = 500m, from y = 800m to y = 1000m and from the bottom to the top of the model domain. Output of instantaneous data of the three wind components. 
@@ -67 +68 @@
 If [../d3par#mask_x mask_x], [../d3par#mask_y mask_y], [../d3par#mask_z mask_z] or [../d3par#mask_x_loop mask_x_loop], [../d3par#mask_y_loop mask_y_loop], [../d3par#mask_z_loop mask_z_loop] are not assigned, all gridpoints are used along the corresponding direction.\\
 Output is done at t = [../d3par#dt_data_output dt_data_output] since [../d3par#dt_domask dt_domask] is not assigned.
+\\
 === 2. Output of two different masks ===
 '''Mask 1:''' xy cross section from x = 500m to x = 1000m and from y = 1000m to 2000m at heights 0m, 50m, 100m, 500m, 1000m and 1200m. Output of instantaneous and time averaged data of the three wind components.\\
@@ -94 +96 @@
     skip_time_domask = 3600.,/
 }}}
-Output starts after 1h simulation time (see [../d3par#skip_time_domask skip_time_domask]) and is done every 10 minutes (see [../d3par#dt_domask dt_domask]). 
+Output starts after 1h simulation time (see [../d3par#skip_time_domask skip_time_domask]) and is done every 10 minutes (see [../d3par#dt_domask dt_domask]).
+\\
 === 3. Output of three different masks ===
 '''Mask 1:''' 1d data along x-direction at y = 50m, 200m, 500m and 1000m and every fifth grid point in z-dircetion. Output of instantaneous data of the w-velocity component.\\