Changes between Version 36 and Version 37 of doc/app/maskedoutput

Timestamp:

Sep 16, 2010 1:38:00 PM (15 years ago)

Author:

weinreis

Comment:

--

doc/app/maskedoutput

@@ -48 +48 @@
 === Examples ===
 The following examples are given for the [../examples/cbl example_cbl run] with a model domain of 2000m x 2000m x 2000m and a resolution of 50.0m.
-==== Output of one mask ====
+==== 1. Output of one mask ====
 '''Mask 1:''' 3d volume data with an extension of 500m x 200m x 2000m from x = 0m to x = 500m, from y = 800m to y = 1000m and from the bottom to the top of the model domain. Output of instantaneous data of the three wind components. 
 {{{
@@ -67 +67 @@
 If [../d3par#mask_x mask_x], [../d3par#mask_y mask_y], [../d3par#mask_z mask_z] or [../d3par#mask_x_loop mask_x_loop], [../d3par#mask_y_loop mask_y_loop], [../d3par#mask_z_loop mask_z_loop] are not assigned, all gridpoints are used along the corresponding direction.\\
 Output is done at t = [../d3par#dt_data_output dt_data_output] since [../d3par#dt_domask dt_domask] is not assigned.
-==== Output of two different masks ====
+==== 2. Output of two different masks ====
 '''Mask 1:''' xy cross section from x = 500m to x = 1000m and from y = 1000m to 2000m at heights 0m, 50m, 100m, 500m, 1000m and 1200m. Output of instantaneous and time averaged data of the three wind components.\\
 '''Mask 2:''' Every second gridpoint in all directions. Output of instantaneous data of the potential temperature.\\
@@ -95 +95 @@
 }}}
 Output starts after 1h simulation time (see [../d3par#skip_time_domask skip_time_domask]) and is done every 10 minutes (see [../d3par#dt_domask dt_domask]). 
-==== Output of three different masks ====
+==== 3. Output of three different masks ====
 '''Mask 1:''' 1d data along x-direction at y = 50m, 200m, 500m and 1000m and every fifth grid point in z-dircetion. Output of instantaneous data of the w-velocity component.\\
 '''Mask 2:''' Output of the potential temperature at position x = 0m, y = 500m, z = 200m, 300m and 400m.\\