Changes between Version 466 and Version 467 of doc/app/initialization_parameters

Timestamp:

Jun 15, 2020 9:26:23 AM (6 years ago)

Author:

oliver.maas

Comment:

--

doc/app/initialization_parameters

@@ -2375 +2375 @@
 '''Attention:'''\\
 In case of ocean mode runs, this parameter gives the temperature value at the sea surface, which is at k=[#nzt nzt]. The profile is then constructed from the surface down to the bottom of the model.
+}}}
+|----------------
+{{{#!td style="vertical-align:top"
+[=#pt_surface_heating_rate '''pt_surface_heating_rate''']
+}}}
+{{{#!td style="vertical-align:top"
+R
+}}}
+{{{#!td style="vertical-align:top"
+0.0
+}}}
+{{{#!td
+Instead of prescribing a [#surface_heatflux surface_heatflux] also a surface heating rate can be prescribed by setting pt_surface_heating_rate to a non-zero value. The surface temperature pt(k=0) will than increase linearly by the the given heating rate (in K/h). Surface cooling can be achieved by using negative values.
+Set [#bc_pt_b #bc_pt_b] = .TRUE.
+
+
 }}}
 |----------------