source: palm/trunk/SOURCE/user_init_plant_canopy.f90 @ 333

 SUBROUTINE user_init_plant_canopy

!------------------------------------------------------------------------------!
! Current revisions:
! -----------------
! Output of messages replaced by message handling routine.
!
!
! Former revisions:
! -----------------
! $Id: user_init_plant_canopy.f90 274 2009-03-26 15:11:21Z heinze $
!
! 211 2008-11-11 04:46:24Z raasch
! Former file user_interface.f90 split into one file per subroutine
!
! Description:
! ------------
! Initialisation of the leaf area density array (for scalar grid points) and 
! the array of the canopy drag coefficient, if the user has not chosen any 
! of the default cases 
!------------------------------------------------------------------------------!

    USE arrays_3d
    USE control_parameters
    USE indices
    USE user

    IMPLICIT NONE

    INTEGER :: i, j 

!
!-- Here the user-defined grid initializing actions follow:

!
!-- Set the 3D-arrays lad_s and cdc for user defined canopies
    SELECT CASE ( TRIM( canopy_mode ) )

       CASE ( 'block' )
!
!--       Not allowed here since this is the standard case used in init_3d_model.

       CASE ( 'user_defined_canopy_1' )
!
!--       Here the user can define his own topography. 
!--       The following lines contain an example in that the 
!--       plant canopy extends only over the second half of the 
!--       model domain along x
!          DO  i = nxl-1, nxr+1
!             IF ( i >= INT(nx+1/2) ) THEN
!                DO  j = nys-1, nyn+1
!                   lad_s(:,j,i) = lad(:)
!                   cdc(:,j,i)   = drag_coefficient
!                ENDDO
!             ELSE
!                lad_s(:,:,i) = 0.0
!                cdc(:,:,i)   = 0.0
!             ENDIF
!          ENDDO 
!--       After definition, please
!--       remove the following three lines!
          message_string = 'canopy_mode "' // canopy_mode // &
                           '" not available yet'
          CALL message( 'user_init_plant_canopy', 'UI0007', 0, 1, 0, 6, 0 )
          
       CASE DEFAULT
!
!--       The DEFAULT case is reached if the parameter canopy_mode contains a
!--       wrong character string that is neither recognized in init_3d_model nor
!--       here in user_init_plant_canopy.
          message_string = 'unknown canopy_mode "' // canopy_mode // '"'
          CALL message( 'user_init_plant_canopy', 'UI0008', 1, 2, 0, 6, 0 )

    END SELECT


 END SUBROUTINE user_init_plant_canopy