Changes between Version 83 and Version 84 of doc/app/runtime_parameters

Timestamp:

Sep 14, 2010 12:33:01 PM (15 years ago)

Author:

raasch

Comment:

--

doc/app/runtime_parameters

@@ -409 +409 @@
 Temporal interval at which time series data shall be output (in s).\\\\
 The default interval for the output of timeseries is calculated as shown below (this tries to minimize the number of calls of {{{flow_statistics}}})
-   {{{IF ( averaging_interval_pr == 0.0 )  THEN}}}
-     {{{dt_dots = MIN( dt_run_control, dt_dopr )}}}
-   {{{ELSE}}}
-     {{{dt_dots = MIN( dt_run_control, dt_averaging_input_pr )}}}
-   {{{ENDIF}}}
+{{{
+   IF ( averaging_interval_pr == 0.0 )  THEN
+      dt_dots = MIN( dt_run_control, dt_dopr )
+   ELSE
+      dt_dots = MIN( dt_run_control, dt_averaging_input_pr )
+   ENDIF
+}}}
 This parameter can be used to assign the temporal interval at which data points shall be output. Reference time is the beginning of  the simulation, i.e. output takes place at times t = '''dt_dots''', 2*'''dt_dots''', 3*'''dt_dots''', etc. The actual output times can deviate from these theoretical values (see [#dt_dopr dt_dopr]). Is '''dt_dots''' < [#dt dt], then data of the time series are written after each time step (if this is requested it should be '''dt_dots''' = 0).
 }}}