Changes between Version 719 and Version 720 of doc/app/errmsg

Timestamp:

Feb 18, 2021 2:50:54 PM (4 years ago)

Author:

suehring

Comment:

--

doc/app/errmsg

@@ -895 +895 @@
 ||[=#PA0680 PA0680]  || Multiple calls to set_reference_date_time detected. The reference date-time must be set only once. || Routine set_reference_date_time can only be called once per program execution. Please check your user code for any additional calls to this routine and remove it. If you did not use any user code, please report the appearance of the error in the ticket system. ||
 ||[=#PA0681 PA0681]  || section_xy/xz/yz not defined for requested xy/xz/yz-cross section output. At least one cross section must be given. || If you specified any data-output quantity for a xy-, xz-, or yz-cross section via [../runtime_parameters#data_output data_output], then you need to also specify the location of at least one corresponding cross section via [../runtime_parameters#section_xy section_xy], [../runtime_parameters#section_xz section_xz], or [../runtime_parameters#section_yz section_yz]. ||
-||[=#PA0684 PA0684]  || Found building surface on non-building coordinates (xs, ys, zenith, azimuth): "xs, ys, zenith, azimuth" || If building_surface_pars is specified within a static input file, the coordinates xs/ys/zs define the location of the horizontal/vertical buildings_surface, while zenith/azimuth define the orientantion of the surface (upward-, northward-, southward-, eastward-, westward-facing). In case this error message appears, the coordinates xs, ys, zs, zenith, and azimuth describing a surface element do not match with the location of a building. Even if xs, ys, zs, are prescribed correctly, mismatches in zenith and azimuth may cause this error. This case, please check carefully your pre-processor. Further information about the data input for surface elements can be found [wiki:doc/app/iofiles/pids/static here]. ||
+||[=#PA0684 PA0684]  || Found building surface on non-building coordinates (xs, ys, zenith, azimuth): "xs, ys, zenith, azimuth" || If building_surface_pars is specified within a static input file, the coordinates xs/ys/zs define the location of a horizontal/vertical buildings surface, while zenith/azimuth define the orientantion of the surface (upward-, northward-, southward-, eastward-, westward-facing). In case this error message appears, the coordinates xs, ys, zs, zenith, and azimuth describing a surface element do not match with the location of a building. Even if xs, ys, zs, are prescribed correctly, mismatches in zenith and azimuth may cause this error. This case, please check carefully your pre-processor. Further information about the data input for surface elements can be found [wiki:doc/app/iofiles/pids/static here]. ||
 ||[=#PA0686 PA0686]  || The relative material fractions do not sum-up to one at horizotal/vertical surface. (i,j) = ... || If building_pars is specified within a static input file, all parameters indicating the relative fraction of wall / window / green surfaces must be given. ||
 ||[=#PA0688 PA0688]  || surface fractions at grid point (j,i) = ( ) are all zero. ||  ||