Changes between Version 701 and Version 702 of doc/app/errmsg

Timestamp:

Jul 17, 2020 7:48:53 AM (5 years ago)

Author:

raasch

Comment:

--

doc/app/errmsg

@@ -719 +719 @@
 ||[=#PA0495 PA0495]   || optimized multigrid method requires nz to be even || You are using the optimized multigrid method, which requires {{{nz}}} to have an even value. Change {{{nz}}} in your parameter file, or choose {{{psolver = 'multigrid_noopt'}}} (but be aware that with an uneven value of {{{nz}}} the multigrid solver can only use one grid level, so you will have no ''multi'' grid levels at all and hence convergence will be very low!). ||
 ||[=#PA0496 PA0496]   || The lowest level where vertical stretching is applied have to be greater than ... || The radiation model does not consider a stretched grid. The assumption of a uniform grid is necessary in parts below the top layer of urban surface (index height nzut). Please adjust [../initialization_parameters#dz_stretch_level_start dz_stretch_level_start] accordingly. ||
-||[=#PA0497 PA0497]   || Prescribing a surface heat flux and a surface heating rate at the same time is not allowed.  ||
-||[=#PA0498 PA0498]   || Stretching in the nested domain is not allowed || You are trying to use vertical grid stretching within the nested domain in combination with pure vertical nesting. This is not allowed due to the interpolation approach between parent and child. Please forgo the vertical stretching for the child. ||
+||[=#PA0497 PA0497]   || constant_heatflux = .TRUE. is not allowed with pt_surface_heating_rate (/=0) = ... ||  ||
+||[=#PA0498 PA0498]   || bc_lr and/or bc_ns in the prerun was set /= "cyclic" || In case of initializing_actions = 'cyclic_fill', the prerun must use cyclic boundary conditions along x and y. Check settings of bc_lr / bc_ns in your prerun parameter file. ||
 ||[=#PA0500 PA0500]   || Unknown turbulence closure: ... || The variable [wiki:doc/app/initialization_parameters#turbulence_closure turbulence_closure] has an unknown value. ||
 ||[=#PA0501 PA0501]   || turbulent inflow/outflow is not yet implemented for RANS mode || Setting [wiki:doc/app/initialization_parameters#turbulent_inflow turbulent_inflow] or [wiki:doc/app/initialization_parameters#turbulent_outflow turbulent_outflow] is not allowed in RANS mode (see namelist parameter [wiki:doc/app/initialization_parameters#turbulence_closure turbulence_closure] to switch between LES/RANS mode). ||