Changes between Version 567 and Version 568 of doc/app/errmsg

Timestamp:

Sep 7, 2018 8:35:39 AM (7 years ago)

Author:

sward

Comment:

--

doc/app/errmsg

@@ -679 +679 @@
 ||[=#PA0455 PA0455]   ||Tunnel width too small   ||[../inipar#tunnel_width_y tunnel_width_y] - 2.0*[../inipar#tunnel_wall_depth tunnel_wall_depth] must be > 2*[../inipar#dy dy] ||
 ||[=#PA0456 PA0456]   ||Tunnel width too large   ||[../inipar#tunnel_width_y tunnel_width_y] must be <= ([../inipar#ny ny]+1)*[../inipar#dy dy] ||
-||[=#PA0457 PA0457]   ||NetCDF attribute lod (level of detail) is not set properly for ... .   ||This error can occur when you try to input topography data via NetCDF. Topography input via NetCDF enables one of two different modes. Therefore the variable {{{lod}}} which determines the mode internally can only have the value 1 or 2. For more information see [/wiki/doc/tec/topography#topo topography implementation].  ||
+||[=#PA0457 PA0457]   ||The maximumn number of agents durin this run was <maximum_number_of_agents>. Consider adjusting the INPUT parameter [../agtpar#dim_size_agtnum_manual dim_size_agtnum_manual] accordingly for the next run. ||This informative message is given at the end of every job that uses the [wiki:doc/tec/mas Multi Agent System]. In order to avoid unnecessarily large files, try to set [../agtpar#dim_size_agtnum_manual dim_size_agtnum_manual] as close to the maximum number of agents during the simulation. ||
 ||[=#PA0458 PA0458]   || soil_moisture must not exceed its saturation value  ||This error can occur when the soil moisture is higher than the saturation moisture for the given vegetation type. Check and may adjust parameters [../lsmpar#saturation_moisture saturation_moisture] or [../lsmpar#soil_moisture soil_moisture]. ||
 ||[=#PA0459 PA0459]   || unknown aerosol type  'aero_type = ...'  ||Chose an appropriate value for [../parpar#aero_type aero_type]. ||