Changes between Version 525 and Version 526 of doc/app/errmsg

Timestamp:

May 23, 2018 1:17:05 PM (7 years ago)

Author:

Giersch

Comment:

--

doc/app/errmsg

@@ -280 +280 @@
 ||[=#PA0237 PA0237]   ||multigrid gather/scatter impossible in non parallel mode   ||You are using the multigrid-solver and are running PALM in non-parallel mode (i.e. on a single processor core), but you have set a multigrid level (using parameter [../inipar#mg_switch_to_pe0_level mg_switch_to_pe0_level]) from where on data shall be collected on core 0 in order to allow for a further coarsening of the grid. Obviously, this does not make sense if only one core is used. Remove this parameter from your NAMELIST-file or set it to value ''-1'' to switch of collection. ||
 ||[=#PA0238 PA0238]   ||more than 10 multigrid levels   ||You have selected the multigrid Poisson-solver ([../inipar#psolver psolver] = ''"multigrid"'') and a numerical grid which allows for more than 10 coarsening levels. This may happen for very large grids where the grid point numbers along x,y,z are given by 2^n^ with n>10. The smallest grid which may cause this error would have 2048^3^ points. However, depending on the chosen domain decomposition, much larger grids might be possible. Choose a different number of grid points to circumvent this problem. ||
-||[=#PA0239 PA0239]   ||The value for "topography_grid_convention" is not set. Its default value is only valid for "topography" = "single_building", "single_street_canyon" or "read_from_file" Choose "cell_edge" or "cell_center".   || See [../inipar#topography_grid_convention topography_grid_convention] for details. ||
+||[=#PA0239 PA0239]   ||The value for "topography_grid_convention" is not set. Its default value is only valid for "topography" = "single_building", "tunnel" "single_street_canyon" or "read_from_file" Choose "cell_edge" or "cell_center".   || See [../inipar#topography_grid_convention topography_grid_convention] for details. ||
 ||[=#PA0240 PA0240]   ||The value for "topography_grid_convention" is not recognized. Choose "cell_edge" or "cell_center".   || See [../inipar#topography_grid_convention topography_grid_convention] for details. ||
 ||[=#PA0241 PA0241]   ||netcdf_precision must contain a "_" netcdf_precision(...)="..."  || Output types can be assigned a NETCDF precision. For that, the output type has to be connected with the precision via "_". See [../inipar#netcdf_precision netcdf_precision] for details. ||