Changes between Version 508 and Version 509 of doc/app/errmsg

Timestamp:

May 22, 2018 12:31:30 PM (7 years ago)

Author:

Giersch

Comment:

--

doc/app/errmsg

@@ -94 +94 @@
 ||[=#PA0069 PA0069]   ||boundary condition: bc_sa_t = "..." requires to set top_salinityflux   ||You have chosen a Neumann boundary condition for salinity at the top (by setting [../inipar#bc_sa_t bc_sa_t] = '' 'neumann' ''), but you did not provide a salinity flux at the top. Please provide parameter [../inipar#top_salinityflux top_salinityflux] in the parameter file. ||
 ||[=#PA0070 PA0070]   ||boundary condition: bc_sa_t = "..." is not allowed with top_salinityflux /= 0.0'   ||You have tried to set both, a Dirichlet boundary condition for salinity at the top (with [../inipar#bc_sa_t bc_sa_t] = '' 'dirichlet' ''), and a salinity flux at the top (with [../inipar#top_salinityflux top_salinityflux] /= ''0.0''). Please decide, if you like to give either the salinity or the salinity flux as top boundary condition, and omit one of the two parameters in the parameter file. ||
-||[=#PA0071 PA0071]   ||unknown boundary condition: bc_..._b ="..."   ||See the respective parameter description in the documentation, and appropriately correct your parameter file. ||
-||[=#PA0072 PA0072]   ||unknown boundary condition: bc_..._t ="..."   ||See the respective parameter description in the documentation, and appropriately correct your parameter file. ||
+||[=#PA0071 PA0071]   ||unknown boundary condition: bc_..._b ="..."   ||See the respective parameter description in the [../inipar documentation], and appropriately correct your parameter file. ||
+||[=#PA0072 PA0072]   ||unknown boundary condition: bc_..._t ="..."   ||See the respective parameter description in the [../inipar documentation], and appropriately correct your parameter file. ||
 ||[=#PA0073 PA0073]   ||boundary condition: bc_..._b = "..." is not allowed with prescribed surface flux ||You have tried to set both, a Dirichlet surface boundary condition for humidity / passive scalar (with [../inipar#bc_q_b bc_q_b] / [../inipar#bc_s_b bc_s_b] = '' 'dirichlet' ''), and a surface latent heatflux / scalar flux (with [../inipar#surface_waterflux surface_waterflux] / [../inipar#surface_scalarflux surface_scalarflux] /= ''0.0''). Please decide, if you like to give either the surface humidity / scalar or the surface latent heatflux / scalar flux as boundary condition, and omit one of the two parameters in the parameter file. ||
 ||[=#PA0074 PA0074]   ||a prescribed surface flux is not allowed with ..._surface_initial_change (/=0) = ... ||If you give the latent heatflux / scalar flux as surface boundary condition (using parameter [../inipar#surface_waterflux surface_waterflux] / [../inipar#surface_scalarflux surface_scalarflux]), you must not specify anything about the surface humidity / scalar at the same time (e.g. with parameter [../inipar#q_surface_initial_change q_surface_initial_change] / [../inipar#s_surface_initial_change s_surface_initial_change]). ||