Changes between Version 451 and Version 452 of doc/app/errmsg

Timestamp:

Jun 9, 2017 12:29:05 PM (8 years ago)

Author:

Giersch

Comment:

--

doc/app/errmsg

@@ -254 +254 @@
 ||[=#PA0212 PA0212]   ||Overhanging topography do not work with particles    || When you have defined an overhanging structure in your topography data the simultaneous use of the Lagrangian particle model could be dangerous because reflection boundary conditions (as well as subgrid-scale velocities) are not realized for downward-facing walls so far.  ||
 ||[=#PA0213 PA0213]   || max_number_of_particle_groups = ... number_of_particle_groups reset to reset to ... || If the [../parpar#number_of_particle_groups number_of_particle_groups] > 10 then is reset to the maximum number of particle groups (at maximum 10 are allowed) ||
-||[=#PA0214 PA0214]   ||version mismatch concerning data from prior run version on file = ... version in program = ...   ||  ||
+||[=#PA0214 PA0214]   ||version mismatch concerning data from prior run version on file = ... version in program = ...   || This error occurs when particle data from the [../iofiles#PARTICLE_RESTART_DATA_OUT restart file] is read and the precursor run was carried out with a different particle binary version than the main run. Repeat the precurser with the current version or carry out the main run with the same version as the precursor. You can check the particle binary version number which is required for the main run in {{{lpm_read_restart_file.f90}}}.  ||
 ||[=#PA0215 PA0215]   ||particle group !# ... has a density ratio /= 0 but radius = 0   || Particles with mass but without radius are not allowed. Please  appropriately correct [../parpar#radius radius] or [../parpar#density_ratio density_ratio] ||
 ||[=#PA0216 PA0216]   || unused   || unused ||