Changes between Version 433 and Version 434 of doc/app/errmsg

Timestamp:

Jun 9, 2017 9:35:55 AM (7 years ago)

Author:

Giersch

Comment:

--

doc/app/errmsg

@@ -318 +318 @@
 ||[=#PA0278 PA0278]   ||no envpar-NAMELIST found in local file ENVPAR some variables for steering may not be properly set   || Some model steering parameters are passed to PALM through a namelist {{{&envpar}}} which is stored in local file {{{ENVPAR}}}. This file is created by the script [source:palm/trunk/SCRIPTS/mrun mrun] which can be used to start model runs. The {{{&envpar}}} namelist was not found. This is possible if you (1) did not use mrun to start your run or (2) changed mrun manually so that the namelist is not properly created.  ||
 ||[=#PA0279 PA0279]   ||wrong component: ...   || This message is produced by the procedure pcm_tendency of the plant canopy model. It calculates drag for velocity components and scalar quantities. The calculated components are: u, v, w, pt, q, e, s (1-7). The subroutine is only called for these 7 quantities. If this error occured, you called the routine from your own code for a component that is out of range. If you wish to do this, you must adjust procedures pcm_tendency and pcm_tendency_ij in file [source:palm/trunk/SOURCE/plant_canopy_model_mod.f90  plant_canopy_model_mod.f90] accordingly. ||
-||[=#PA0280 PA0280]   ||   || unused ||
-||[=#PA0281 PA0281]   ||   || unused ||
+||[=#PA0280 PA0280]   ||No tunnel width is given.   || This error occurs if you have set [../inipar#topography topography]='' 'tunnel' '' in you parameter file but you did not specify [../inipar#tunnel_width_x tunnel_width_x] or [../inipar#tunnel_width_y tunnel_width_y]  ||
+||[=#PA0281 PA0281]   ||Inconsistent tunnel parameters: tunnel can only be oriented either in x- or in y-direction. ||Please do not specify [../inipar#tunnel_width_x tunnel_width_x] and [../inipar#tunnel_width_y tunnel_width_y] in the parameter file at the same time. ||
 ||[=#PA0282 PA0282]   ||   || unused ||
 ||[=#PA0283 PA0283]   ||no sufficient convergence within 1000 cycles   || Still after 1000 cycles of the multigrid-solver the divergence residual is larger than the residual limit given by [../inipar#residual_limit residual_limit]. Try to increase the residual limit, or fix the number of multigrid cycles (see [../inipar#mg_cycles mg_cycles]). In any case, carefully check if the divergence of the velocity field is sufficiently reduced by the multigrid solver. This can be done by comparing the divergence before and after the call of the multigrid solver which is printed in the RUN_CONTROL file. ||