Changes between Version 333 and Version 334 of doc/app/errmsg

Timestamp:

Jun 7, 2017 10:26:58 AM (8 years ago)

Author:

Giersch

Comment:

--

doc/app/errmsg

@@ -100 +100 @@
 ||[=#PA0075 PA0075]   ||boundary condition: bc_uv_b = "..." is not allowed with constant_flux_layer = .TRUE. ||You have tried to set both, a Neumann surface boundary condition for horizontal velocity (with [../inipar#bc_uv_b bc_uv_b] = '' 'neumann' ''), and a constant flux layer between the surface and the first vertical grid point (with [../inipar#constant_flux_layer constant_flux_layer] = ''.TRUE.''), which are contradicting conditions. Either set [../inipar#constant_flux_layer constant_flux_layer] = ''.FALSE.'' or [../inipar#bc_uv_b bc_uv_b] = '' 'dirichlet' '' in the parameter file. ||
 ||[=#PA0076 PA0076]   ||unknown boundary condition: bc_uv_b = "..."   ||See parameter [../inipar#bc_uv_b bc_uv_b] for allowed values, and appropriately correct your parameter file.  ||
-||[=#PA0077 PA0077]   ||unknown boundary condition: bc_uv_t = "..."   ||See parameter [../inipar#bc_uv_b bc_uv_b] for allowed values, and appropriately correct your parameter file.  ||
+||[=#PA0077 PA0077]   ||unknown boundary condition: bc_uv_t = "..."   ||See parameter [../inipar#bc_uv_t bc_uv_t] for allowed values, and appropriately correct your parameter file.  ||
 ||[=#PA0078 PA0078]   ||rayleigh_damping_factor = ... out of range [0.0,1.0] ||Adjust the value of [../inipar#rayleigh_damping_factor rayleigh_damping_factor] in your parameter file to the allowed range. ||
 ||[=#PA0079 PA0079]   ||rayleigh_damping_height = ... out of range [0.0, ...]  ||Adjust the value of [../inipar#rayleigh_damping_height rayleigh_damping_height] in your parameter file to the allowed range. This error may appear if you have reduced the domain height in your current run (e.g. by reducing the number of vertical grid points) without adjusting the height at which Rayleigh damping shall start. ||