Changes between Version 180 and Version 181 of doc/app/errmsg

Timestamp:

Mar 26, 2014 12:04:46 PM (11 years ago)

Author:

suehring

Comment:

--

doc/app/errmsg

@@ -352 +352 @@
 ||[=#PA0310 PA0310]   ||remote model "..." terminated with terminate_coupled_remote = ... local model "..." has terminate_coupled = ...   ||  ||
 ||[=#PA0311 PA0311]   ||number of gridpoints along x or/and y contain illegal factors only factors 8,6,5,4,3,2 are allowed   ||In case that [../inipar#fft_method fft_method]='temperton-algorithm', the number of horizontal grid points ([../inipar#nx nx]+1, [../inipar#ny ny]+1) must be composed of prime factors 2,3 and 5. Higher prime factors such as 7 are not allowed. Please ensure that these restrictions are fulfilled or use 'singleton-algorithm' as [../inipar#fft_method fft_method].  ||
-||[=#PA0312 PA0312]   ||Time step has reached minimum limit. \\dt = ... s Simulation is terminated.\\old_dt = ... s\\dt_u = ... s\\dt_v = ... s\\dt_w = ... s\\dt_diff = ... s\\u_max = ... m/s k=... j=... i=...\\v_max = ... m/s k=... j=... i=...\w_max = ... m/s k=... j=... i=...   || Matthias ||
+||[=#PA0312 PA0312]   ||Time step has reached minimum limit. \\dt = ... s Simulation is terminated.\\old_dt = ... s\\dt_u = ... s\\dt_v = ... s\\dt_w = ... s\\dt_diff = ... s\\u_max = ... m/s k=... j=... i=...\\v_max = ... m/s k=... j=... i=...\w_max = ... m/s k=... j=... i=...   ||The time step is determined according to the CFL criterion to assure a stable numerical solution. This error message means that the required minimum time step, determined from the three velocity components, is several orders of magnitude smaller than [../d3par#dt_max dt_max]. Due to the large number of complex reasons it should be noted that this list is not complete, but it is intended to give general hints how to proceed in case of this error message. First, check for a unrealistic value of [../d3par#dt_max dt_max] in the NAMELIST file. Moreover, this error message may indicate for unrealistic settings of e.g. [../inipar#bc boundary conditions] or other NAMELIST parameters. For very small vertical grid spacing [../inipar#dz dz] this error might also occur if [../inipar#roughness_length roughness_length] >= [../inipar#dz dz]. Please also check if this error appears if you run without USERCODE. To compile and run the PALM and USERCODE with DEBUG-options might also give sometimes valuable hints. 
+To be continued.||
 ||[=#PA0313 PA0313]   ||illegal value for parameter particle_color: ...   || Farah ||
 ||[=#PA0314 PA0314]   ||illegal value for parameter particle_dvrpsize: ...   || Farah ||